CB-1003 Pilaster

25 Year Limited Warranty

You're making a beautiful upgrade to your home and we're here to help protect that investment. We guarantee that your polyurethane millwork will be free from manufacturing defects for twenty-five years from the original date of purchase.

Warranty Conditions and Limitations

This warranty covers material defects in our polyurethane products when used in standard applications where temperatures do not exceed 150°F. It does not cover labor, consequential or incidental damages. This warranty is not transferable and applies to the original purchaser only.

• Polyurethane products are for decorative uses only.
• Polyurethane products need a finish coat of paint during installation; it is the purchaser's responsibility to make sure their paint works well with the product (test and let dry on a small piece first).
• Before installation, allow your polyurethane product to acclimate to room temperature for 15 minutes.
• All polyurethane moldings must be installed with tight fitting joints (see installation instructions) as well as adhesive between the joints to prevent seams from expanding during changes in season.

We're Ready to Help

Unlike a car, not much can go wrong with a polyurethane product since polyurethane doesn't absorb moisture and won't be affected by insects. However, in the rare event that you do encounter a defect with your product, we're here and ready to help. Just give us a call and we'll work with you to identify the problem and, in case of defect, supply you with replacements.

RETURNS

• 90 day return window with no restocking fees
• Products must be unused/new and in their original boxes
• Customer is responsible for return shipping cost (we are happy to help arrange shipping)
• Partial returns where the quantity discount tier would change are refunded the difference between the original total and the total based on the kept quantity (see example)

Materials & Tools Needed
Hammer / Finish Nails / Nail Set / 1" Brad Gun
Adhesive / Caulking Gun
Tape Measure / Pencil
Level
Caulking (paintable latex)
Sandpaper Coarse / Fine

Caution
Our polyurethane corbels are decoration only and are not load bearing.

Getting Started
Lightly mark with a pencil where your decor will be placed using a level to make sure it will be plumb when installed.

Dry fit your pieces before applying the adhesive.

Painting
Many of our decorative pieces have very intricate details and because of their final location can be very hard to finish once installed. We recommend painting your decor before installing it. You can then touch up any areas that need attention after the installation is complete.

Adhesive
The adhesive should be beaded along the touching edges of the wall and then a few small nails will hold the decor in place while the adhesive sets. You can use any adhesive that is rated for use with polyurethane (check the back of the label) -- we have had great success using Red Devil Construction Adhesive, Loctite Powergrab and PL Premium Polyurethane Adhesive, all of which work well and are readily available at most home improvement stores.

Installation
On the back side, run a 1/4" continuous bead of adhesive around the outer edge of the decor.

Place the decor using your marks to align. Verify that the decor is level before firmly pushing into position. If necessary, use masking tape or small finish nails to hold the decor in place until the adhesive dries. Do not nail or screw into our gold products.

Clean up any adhesive mishaps with a cloth.

Apply caulk to the edges to create the appearance that the decor is part the wall. Touch up with paint as needed.